Do you need to access the engine or other parts underneath the cab of your Hino 700? Tipping the cab can provide easy access, but it can also be a risky operation if not done correctly. In this guide, we will walk you through the process of How to tilt cab on Hino 700? safely and efficiently.
Preparing for the Tilt
Before beginning, ensure the truck is parked on a flat, level surface and that the brakes are properly engaged. Next, step out of the truck and move to the front of the cab, opening the hood latch and lifting it up to secure it to the open position. This will create the clearance required to tip the cab.
Locating the Tilt Locks
Each Hino 700 truck is equipped with tilt locks that hold the cab in place during operation. These locks are typically located on either side of the cab, underneath the body paneling. Look for two or more locking pins with cables leading to a central pull handle. Identify the location of these tilt locks before proceeding.
Disabling the Electric Cables
On the passenger side of the truck, locate the electric cables that supply power to the cab's electrical systems. Carefully unplug these cables and secure them away from the working area. Failure to do so could result in damage or malfunction during the tilt.
Lowering the Tilt Cylinder
Using the handle located between the tilt locks, gently pull it towards you to release the hydraulic pressure in the tilt cylinder. This will lower the back of the cab and create a gap between the cab and the chassis. You may also need to lower the corners of the cab using a wrench to release the locking nuts.
Activating the Tilt Locks
Once the cab is in the lowered position, engage the tilt locks by pulling up on the handles until they snap into place. This will secure the cab in the tilted position and prevent unwanted movement. Ensure that the locks are properly engaged before beginning work underneath the cab.
Performing the Work
Now that the cab is tilted and locked into place, it's time to perform whatever maintenance or repairs are required. This might include changing the oil, inspecting belts or hoses, replacing a starter motor, or any other necessary work. Be sure to stay safe and wear appropriate personal protective equipment.
Lowering the Cab
Once the maintenance is complete, use a wrench to loosen the locking nuts at the corners of the cab. Carefully lift the back of the cab with the tilt handle and raise it to its original position. Once the back of the cab is in its highest position, release the tilt lock handles and allow the cab to return to its normal position. Ensure the locks have properly disengaged before proceeding.
Reconnecting the Electric Cables
Gently slide the electric cables back into place and secure them to their sockets on the passenger side of the truck. Double-check that all the connections are solid and that there are no loose wires or splices before closing the hood.
Test Driving the Truck
In general, it's always a good idea to test drive the truck following any significant maintenance to ensure everything is working as intended. Take a short test drive, checking for leaks, obstructions under the cab, or any other irregularities that could pose a safety hazard.
Conclusion
Tilting the cab of a Hino 700 can provide easy access to critical systems and components, but it's important to follow correct procedures to prevent accidents or damage to the truck. Taking time to prepare, identify the tilt locks, disable electrical systems, and perform the work safely can help ensure a successful repair while also protecting your safety.